
1) Locate 3 holes in StingRay frame just in front of
rear wheel on lower chain stay.
2) Slide Training wheel bracket just below frame between
chain and frame. Be sure that training wheel bracket
is facing correctly; the bend should face down when
the bracket contacts the frame.
3) Insert 3 bolts through frame and training wheel
bracket. Install washer and nut for each bolt.
Tighten all bolts securely.
4) Install training wheels.
Order: Training wheel bolt, training wheel, 1st washer,
training wheel bracket, 2nd washer and fi nally, nut.
5) When tightening training wheels note the adjustment
slot position. Wheels should be even height left and
right. Adjust so that training wheels are approximately
1/4" above the ground when bike is held straight.
6) Check training wheel bracket bolts, and training wheel
bolts periodically for looseness. Tighten as needed.
StingRay Training Wheel Installation Instructions
STEP 1 and 2
STEPS 3 and 4
STEP 5
Komentáře k této Příručce