Schwinn 202 Uživatelský manuál

202 Schwinn® Recumbent Exercise Bike Parts List Full Size Hardware Chart Product Illustration Assembly Instructions 202 Recumbent Ex

l to Seat Assembly . Assembly hardware required: (4) M8 Allen Bolts 16mm (item #22)

Attach Front Stabilizer Tube and Pedals to Main Unit Assembly Hardware Required: ) M8 Bolt 75mm long (item #16) (2) Curved Washers (item

Assembly Stage #4 at Rail and Lower Base Frame to MAttach Se ain Unit 9 #22) Assembly Hardware Required: (7) Allen Bolts 16 mm long (item

Before proceeding to step 11 please complete the following steps. Failure to do so could lead to damage to the handgrip heart rate wires! 1) Remov

Assembly Stage #5 Attach Console Mast to Main Unit 31 22192726252956573028STEP133334STEP1458STEP15 31 tep 13: Run CONSOLE MAST (

Step 15: Attach UPPER COMPUTER CABLE (#28) and HR CABLE (#29) to under de of COMPUTER (#34). Place COMPUTER (#34) on top of CONSOLE MAST (#30), the

Troubleshooting the Schwinn 202 Recumbent nd connector orientation made to the computer. ROBLEM: No Heart Rate on computer… OLUTION): 1. Check

IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, please read the following precautions before using the Schwinn 202. 1. It is

202 Schwinn Recumbent Bike Parts List, Hardware Chart, and Assembly Instructions Assembly of the 202 Recumbent Bike is divided into 5 easy stages;

Parts List Check Quantity Description Reference # __ 8 Allen Bolt M8 x P1.25 x 45mm 1 __ 15

Hardware Chart Allen Bolt M8xP1.25x16mm Stage#2 Allen Bolt M8xP1.25x mm Note: Please verify you have all cor

202 Assembly Drawing with Reference Numbers 302222322201932312019181617282122261925292711241022284795657333458315141312

Replacement Parts List Reference # Description 3 Seat Pin Adjustment Knob

Instructions IMPORTANT!: To ensure ease of assembly please verify the size and quantity of all the required assembly hardware and parts with the encl

TS Step 3: Attach SEAT BAC ) with 4 ALLEN BOL(#1) and 4 WASHERS (#2). Tighten Bolts. Note: Finished seat should look like picture below: K (#5) t